LensCoat Nikon Z 24-70mm f/2.8 S: Fit and Installation Guide

Quick answer

The LensCoat Nikon Z 24-70mm f/2.8 S cover fits precisely over your lens's zoom and focus rings. Follow the alignment and adhesion steps below to ensure a secure, bubble-free fit.

Installation steps

1. Clean the lens surface: Wipe the lens barrel with a microfiber cloth to remove dust and oils. This helps the cover adhere evenly and prevents bubbles. Check that the lens is completely dry before moving on.
2. Align the cover with the zoom ring: Position the cover so its cutouts match the zoom and focus rings. Start at the lens mount and gently slide the cover into place, smoothing as you go. Do not stretch the cover; it should sit naturally without force.
3. Press and smooth the cover: Use your fingers to press the cover firmly against the lens barrel, working from the center outward to eliminate any air bubbles. If a bubble persists, lift the cover slightly and re-press instead of tearing the material.
4. Attach the optional piece: If your cover includes an optional piece for the lens hood or another section, align it carefully and press it into place for full coverage. Make sure the optional piece does not overlap the main cover, which could cause peeling.
5. Check for full coverage: Inspect the entire lens to ensure the cover lies flat and no areas are exposed. Adjust as needed before the adhesive sets. Leave the lens undisturbed for a few minutes after installation to allow the cover to bond.

Product facts

• LensCoat® Nikon Z 24-70MM F/2.8 S: The LensCoat Nikon Z 24-70mm f/2.8 S cover is designed specifically for the Z series lens and includes an optional piece for part of the lens. This ensures a custom fit that protects the lens from scrapes and bumps while preserving its resale value.