Install LensCoat on Nikon 70-300 f/4.5-5.6E AF-P VR

Quick answer

Installing a LensCoat on your Nikon 70-300 f/4.5-5.6E AF-P VR is straightforward: clean the lens, align the cover pieces, and press them firmly into place. The cover protects from scrapes and bumps while making the lens less noticeable to wildlife.

Installation steps

1. Clean the lens surface: Wipe the lens barrel clean with a microfiber cloth. Remove all dust, oil, and moisture. A clean surface ensures the adhesive sticks firmly. Skipping this step can cause the cover to peel off later.
2. Align the main body piece: Peel the backing from the largest piece and align it with the lens barrel. Match the cutouts for the AF and VR controls. Start from one edge and press gradually to avoid air bubbles. If you misalign the cutouts, the controls may be blocked. Reposition gently before pressing fully.
3. Apply the remaining pieces: Attach the smaller pieces for the zoom ring, focus ring, and lens hood area. Press each piece firmly from the center outward to remove air pockets. Work slowly; rushing can trap air bubbles that are hard to remove later.
4. Final press and check: Run your fingers along all edges to ensure full adhesion. Check that all control cutouts are clear and the cover lies flat. Let the adhesive cure for 24 hours before heavy use. Using the lens immediately may loosen the edges. Patience ensures long-lasting protection.

Product details

• LensCoat® Nikon 70-300 f/4.5-5.6E AF-P VR: LensCoat for the Nikon 70-300 f/4.5-5.6E AF-P VR offers protection from scrapes and bumps, preserving resale value, and helps break up the lens shape for wildlife photography. This means your lens stays in better condition for longer, and you can get closer to birds and animals without being spotted.