How to Install a LensCoat on Canon 600mm Non-IS
By Lenscoat | Published: 2026-10-20
Category: How-to Guides
Learn step-by-step how to fit a LensCoat cover on the Canon 600mm f/4 non-IS lens, including alignment, window placement, and common mistakes to avoid.
Quick answer
To install a LensCoat on your Canon 600mm f/4 non-IS, start by cleaning the lens, then align the cover's clear windows with the auto focus controls and distance scale, and stretch the neoprene evenly from the front to the rear, checking the alignment as you go.
Why a snug fit matters for your Canon 600 non-IS
The LensCoat Canon 600 NON IS is cut specifically for the Canon 600 f/4 non-IS body. That means the cover follows the contours of the barrel, including the clear plastic windows over the auto focus controls and the distance scale. A correct fit keeps those windows aligned so you can read settings and adjust focus without removing the cover.
Because this is a non-IS model, the cover's design matches the older barrel shape. If you later switch to an IS version, the cover may not line up with the control windows, so check your lens model before ordering.
Why the clear windows matter
The LensCoat for the Canon 600 non-IS has clear plastic windows over the auto focus controls and the distance scale. These aren't just cosmetic. They let you see and adjust settings without peeling the cover back, which keeps the protection in place while you shoot.
Step-by-Step Installation for the Canon 600mm Non-IS
- Prepare the lens and cover: Set the lens on a clean, padded surface and ensure the cover's orientation matches the lens barrel. The clear windows should align with the autofocus controls and distance scale. Confirm the cover's orientation before stretching it over the lens to avoid rework.
- Start from the front element: Slip the narrower end of the LensCoat over the front of the lens first, then work it back toward the mount. Stretch gently and evenly to avoid bunching. If the cover resists, do not force it—adjust the seam alignment and try again.
- Align the windows and hole: Position the clear plastic windows over the auto focus controls and distance scale. Line up the small hole on the last segment with the red dot or index mark on the lens body. Check that all controls remain accessible before moving to the next step.
- Smooth and secure the cover: Work the cover evenly around the barrel, smoothing out wrinkles as you go. Make sure the cover sits flat and the windows stay aligned with the controls. Once aligned, give the cover a final tug to confirm it stays put during handling.
What the LensCoat Canon 600 Non-IS cover offers
- LensCoat® Canon 600 NON IS: The LensCoat for the Canon 600 f/4 non-IS includes clear plastic windows over the autofocus controls and distance scale, plus a small hole on the last segment that lines up with the red dot. You can keep the cover on while adjusting focus or checking the distance scale, and the alignment hole helps you position the cover accurately without blocking the red dot.
LensCoat® Canon 600 NON IS
