How to Clean and Maintain Your LensCoat LensSack Pro

Quick answer

Clean your LensCoat LensSack Pro by hand with mild soap and water, then air dry. Always remove the aluminum mounting plate first to avoid corrosion.

Step-by-step cleaning process

1. Remove the mounting plate: Unscrew the 3/8”-16 mounting screw and slide the plate out of its sleeve. Set it aside in a dry place. Common mistake: washing with the plate still inside can trap water and cause corrosion.
2. Shake out loose debris: Take the empty LensSack Pro outside and shake it vigorously. Use your fingers to work out any sand or grit from the seams and corners. Checkpoint: If you skip this step, grit can scratch your camera gear when you use the bag later.
3. Hand wash with mild soap and cool water: Fill a basin or sink with cool water and add a small amount of mild detergent (like dish soap or a gentle laundry liquid). Submerge the LensSack Pro and gently squeeze the neoprene. Do not scrub or twist the fabric. Common mistake: using bleach, fabric softener, or machine washing can break down the neoprene foam and outer fabric.
4. Rinse thoroughly: Drain the soapy water and refill the basin with clean cool water. Submerge and squeeze the bag repeatedly until no suds remain. Repeat if needed. Checkpoint: leftover soap residue can attract dirt and cause the neoprene to feel sticky.
5. Air dry completely before reassembly: Lay the LensSack Pro flat on a clean towel or hang it over a drying rack away from direct sunlight and heat sources. Let it dry fully, which can take 24–48 hours depending on humidity. Common mistake: putting the mounting plate back on a damp bag can lead to mold or rust. Wait until the neoprene feels completely dry to the touch.

Product fact

• LensCoat® LensSack™ Pro: The mounting plate is made of lightweight aircraft-grade aluminum with a 3/8”-16 mounting screw. You must remove the plate before washing to prevent moisture damage to the aluminum and screw threads.